Is Brake Line Fitting On Demco Designed For 3/16-inch Brake Line
Updated 05/30/2017 | Published 05/26/2017
Question:
Is the input threaded for a standard flared 3/16 brake line fitting?
asked by: Les S
1
Helpful Expert Reply:
The fitting on the Demco Replacement Hydraulic Cylinder Assembly # DMSB9776M is designed for a flared 3/16-inch brake line. I confirmed this with my contact at Demco.
expert reply by:
Jeffrey L
1
Product Page this Question was Asked From
Replacement Hydraulic Cylinder Assembly for Demco 10" Marine Free Backing Brakes - Right Side
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- RH
- Wheel Cylinder
- 10 Inch
- Uni-Servo
- Demco
more information >
Continue Researching
- Q&A: Replacement Bearing Kit Recommendations for a 1972 Airstream Overlander
- Q&A: Replacement Drum Brake Wheel Cylinders for Demco KK460SS Kar Kaddy Tow Dolly
- Q&A: Recommended Replacement Brake Assemblies For Eagle Trailer Drum Brakes
- Q&A: Replacement Actuator for an Older Atwood 85736
- Q&A: Replacement Wheel Cylinder for EZ Loader Boat Trailer
- Q&A: Troubleshooting Tekonsha Prodigy P2 Not Sending Power on the Blue Wire
- Q&A: How to Convert Drum Brakes to Disc Brakes on a 2005 Boat Trailer
- Article: How to Measure a Trailer Axle
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Trailer Wiring Diagrams
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide