Is a Lift or Jack Needed to Install Curt Hitch C13292 on a 2017 Buick Envision
Published 05/18/2017
Question:
I am looking at the following hitch Item # C13292 to install on my vehicle. My question is do you need a vehicle lift to raise the vehicle to gain access to the bottom of the vehicle to install the hitch ?
asked by: Paul L
0
Expert Reply:
The rear of your 2017 Buick Envision sits up high enough that you would not need to lift the rear of the vehicle to install the Curt hitch part # C13292. In the linked installation instructions the vehicle is up on a lift but that's done just to make taking pictures a bit easier.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Comparing Weight and Functions of Hollywood Racks Trail Rider and Swagman XC Bike Rack
- Q&A: Does Advent Air Rooftop RV Air Conditioner Need a Mounting Bracket
- Q&A: Parts Needed to Tow With 2018 Buick Envision
- Q&A: Is Any Grease Needed When Installing Kat's Block Heater in Vehicle
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Raise Your Travel Trailer Height
- Q&A: What do I Need to Tow a Small Trailer with a 2015 Buick Envision
- Q&A: Gooseneck Hitch for FL70 Freightliner
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)