Why Would Only One Andersen Leveler Ever Be Used on a Trailer
Published 05/17/2017
Question:
Hi Is it not possible to buy the AM3620 and AM3604 and use both as levelers for a tandem axle travel trailer if you were to place the AM3620 behind the rear tire and back onto it? Thanks
asked by: Mike
0
Expert Reply:
It wouldn't be a bad idea to have both the part # AM3604 and the # AM3620 for differing leveling situations as the # AM3620 is a bit taller, but you really would only ever need to use one at a time. It can only raise one side of the trailer. Raising both would defeat the purpose and only one axle would need to be raised.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How To Choose The Correct Leaf Springs For My Trailer
- Q&A: Does Ducted Furrion Chill Cube With Heat Pump Include Remote
- Q&A: Does The Ducted Air Distribution Box LC64DX Work With Furrion Chill Cube With Heat Pump?
- Q&A: Is Pre-Charge Resistor Needed When Installing Rich Solar NOVA 3k12
- Q&A: Need Replacement Axle for LCI 4400 LB axle that says 95.5/75
- Q&A: Recommended Longest Extended Pin Box for a Lippert 1621 Bolt Pattern
- Q&A: Bolt Hole To King Pin Measurement For The Lippert 1716 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Tire Sizing
- Article: How to Change a Trailer Tire
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Towing a Trailer? Let's Talk About Brake Controllers