What is the Bolt Pattern for Brake Mounting Flange 4-50
Updated 04/21/2017 | Published 04/20/2017
Question:
Hello - I would like to know the bolt mounting pattern on this flange. What is the distance between diametrically opposite holes? Thanks.
asked by: Ananth K
0
Expert Reply:
Brake mounting flange # 4-50 has a standard 4 bolt pattern for 8,000 pound brake axles. Diagonally the holes are spaced 5 inches apart on center. Side to side they are 3-7/16 inches apart on center. And top to bottom they are 3-5/8 inches apart on center. I included a picture showing these measurements for you. Basically the part number, 4-50, indicates a 4 on 5 bolt pattern.
expert reply by:
Michael H
0
click to enlarge
Product Page this Question was Asked From
Trailer Brake Mounting Flange for 3-1/2" Axles, 12-1/4" Brake Assemblies
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- Electric Drum Brakes
- Hydraulic Drum Brakes
- Brake Mounting Flange
- 12-1/4 Inch
- 3-1/2 Inch Diameter Axle
- Dexter
more information >
Continue Researching
- Q&A: What is the Four Bolt Brake Mounting Flange for 8,000 Lb Axles
- Q&A: What Does 5 on 5 And 5 on 4-1/2 Mean For Trailer Wheels
- Q&A: Can Grease be Used in Oil Bath Hub
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Complete Towing Setup for 2017 Toyota Highlander SLE AWD for 3,850 lb Trailer
- Q&A: Brake Mounting Flange Available for 8,000 Pound, 3-1/2 Inch Axle.
- Q&A: Comparing Benefits of Greased Hubs vs Oil Bath Hubs
- Q&A: Recommended Parts To Convert Drum To Disc Brakes On EZLoader Trailer With 3,500 Lb Axle
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Double-Eye Trailer Suspension System Review
- Article: Performance Chips and Modules
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Lighting Requirements