Mounting Fulton Swivel Marine - Weld On Jack # FTJ120W0301 To Replace Exising Fulton Jack
Updated 02/15/2011 | Published 02/14/2011
Question:
What is the ID of the mounting hole for this jack? I need a replacement jack for a Fulton weld-on/spring swivel jack with an ID of ~2-1/2 inches for a boat trailer 1000/1200lb is likely certain overkill, but should make it more durable...
asked by: Mark
Expert Reply:
I contacted our representative at Fulton about the Fulton Round, Snap-Ring Swivel Marine Jack, part # FTJ120W0301. The inner diameter of the mounting hole is 2-1/2 inches. He informed me that up to a few years ago the Fulton jacks were made in Wisconsin, but are now made in China. At that time the mounts were tightened up, so the mounting holes were changed slightly.
He informed me that part # FTJ120W0301 includes a new weld-on mount and chances are that you may have to replace your weld on mount to use the Fulton # FTJ120W0301 jack.
You can check toward the bottom of your jack for a stamping that will indicate where your jack was manufactured.
Continue Researching
- Q&A: Recommendation to Replace Shelby 5756A Trailer Jack
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Replacement for Fulton Magnum Series Trailer Jack
- Q&A: Is there a Higher Rated Fulton Jack that Uses the Same Swivel Mount as My TJ120W0301?
- Q&A: Replacement Jack for Bulldog Model 130 Marine Jack
- Article: Best Boat Trailer Jacks
- Q&A: Jack Recommendation to Replace Shelby Jack 5754A on Trailer
- Q&A: Replacement For Shelby 5776 Trailer Swivel Jack
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Tire Sizing
- Article: Trailer Maintenance Schedule
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How To Read A Tire Sidewall
- Article: How to Measure for Trailer Hitch Drop