Replacement Fan Blade for Ventline V2294 Ventadome Vent
Updated 04/18/2017 | Published 04/17/2017
Question:
I have a Ventline v2294 in a 1994 Kit Companion trailer. The bore is just about an 1/8 of an inch, and has a flat side. This is the closest I can find, and want to know if it will fit.
asked by: Jason M
Expert Reply:
The Replacement Fan Blade for Ventline Ventadomes # BVC0466 referenced in your question is designed to fit 12V Ventline Ventadomes with .125 inch diameter shafts, so should work great with the 1/8 (.125) inch bore you mentioned in your question. The overall fan size is 6 inches.
I have also included a link that will take you to our available selection of replacement fan blades for you to look over.
Product Page this Question was Asked From
Replacement Fan Blade for Ventline Ventadomes
- Accessories and Parts
- RV Vents and Fans
- Roof Vent
- Fan Blade
- Ventadome
- Ventline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Components for a Dexter 5100 Pound Axle
- Q&A: Replacement Fan Motors and Blades for B2000R and Elixir S545A3
- Q&A: Remote Compatible with MaxxFan Plus 00-04900kx
- Q&A: Replacement Hardware and Backing Plate For Lippert SolidStep Fold-Down Steps
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Q&A: Replacement Exterior Ladder for 2020 Jayco North Point
- Q&A: Replacement Range Hood Motor for Ventline Model PH CC0431-09
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Repair an RV Roof
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Double-Eye Trailer Suspension System Review
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?