4-Pole Trailer Wiring Harness Mounting Bracket for Use with Curt Hitch
Updated 03/28/2017 | Published 03/25/2017
Products Featured in This Question
Question:
Hello Im an owner of Subaru Outback 2008. I have this product Curt C12284 Do you think the CURT 58000 Easy Mount Electrical Bracket for 2inch Receiver Tube will fit to my trailer hitch ? Or I need something else ?
asked by: Lachezar L
Expert Reply:
Curt Easy Mount Wiring Bracket # C58000 is meant for 2-inch hitches, so for your 1-1/4-inch Class II hitch # C12284 you are better off using # C58002 for a 4-pole flat type trailer connector. Or, you can leave the wiring inside the car when you are not towing to protect the connector from damage and corrosion. Applying dielectric grease # 11755 to all connectors also helps prevent corrosion.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- For Towing
- Class II
- 300 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How Does Lippert Center Point Air Ride Trailer Suspension Install and Can it be Used on 21k Trailer
- Q&A: Replacement Trailer Hub and Drum Assembly for Dexter 8-389-91
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended Trailer Hitch Receiver For 2005 Subaru Outback XT Limited Wagon With MT Turbo
- Q&A: Bolt Hole Spacing of Curt C13900 Multi Fit Class III Hitch
- Q&A: Recommended Hitch For A 2009 Subaru Outback Wagon XT
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop