Draw Tite Hitch that Fits 2000 Chevy S-10
Updated 03/21/2017 | Published 03/20/2017
Question:
Will a drawtite #75064 towbar fit my 2000 chevy s10 longbed? If not is there a way to make it work? Looks like there needs to be holes in frame to make it? Thank you
asked by: Al G
0
Expert Reply:
I can't find any fit info for that part number. Even went to Draw Tite's site and they have no record of it and they keep all of that normally. Where did you find the hitch?
Instead the Draw Tite hitch part # 75085 is a fit for your truck and would be the easiest route for installing a hitch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Class III Receiver for 1999 Chevy S-10 Extreme Sportside
- Q&A: Help Picking Out Trailer Hitch for 1997 Chevy S-10 with Sportside and Roll Pan Bumper
- Q&A: Recommended Hitch for a 2002 Chevy S-10
- Q&A: Most Concealed Hitch for a 2023 Ford Edge
- Q&A: Concealed vs. Visible Crosstube for 1999 Chevy S-10 With Factory Step Bumper
- Q&A: Troubleshooting a Wiring Harness for a 2022 Volkswagen Tiguan That Lights Don't Turn Off
- Q&A: Troubleshooting Tekonsha T-One Trailer Harness Not Working on 2012 GMC Acadia
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide