Trailer Hitch Recommendation for 1970 Ford F-100 with Standard Bumper
Updated 03/20/2017 | Published 03/19/2017
Products Featured in This Question
Question:
I have a 1970 f100 with the standard chrome rear bumper..not the step bumper ..And I would like the receiver to be located right under said bumper ..Can you tell me what hitch to buy...
asked by: Mitch
0
Expert Reply:
For your 1970 Ford F-100 with a standard chrome bumper the Draw Tite hitch part # 41001 is a confirmed fit that will work well for you. The hitch opening will be right underneath the bumper as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Trailer Hitch Receiver - Multi - Fit - Class IV - 2"
- Trailer Hitch
- For Towing
- Class IV
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Side Plate and Bolt Hole Spacing Measurements for Curt Trailer Hitch # C14082
- Q&A: Bolt Hole Spacing of Curt Class IV Hitch Receiver 14082
- Q&A: Trailer Hitch Side Brackets and Mounting Hole Dimensions for 2009 Ford F-Series Cab and Chassis
- Q&A: Hitch to Fit Older Vehicle with 34 inch Wide Frame
- Q&A: What Torque Should Be Used For U-Bolt Nuts On Trailer Suspension
- Q&A: Curt Trailer Hitch Receiver # C14082 Tube Height From Mounting Flange For 1973 Ford F-100
- Q&A: Mounting Hole Dimensions of Curt Trailer Hitch C14048 for Cab and Chassis