How Does Kat's Heaters Plug Cover for Power Cords KH28405 Install on Frost Plug Heater
Updated 03/20/2017 | Published 03/19/2017
Products Featured in This Question
Question:
I do a lot of driving on snowy, salted road conditions. Only have the photos to go on, but looks to me like the slot in the tab on the end of the restraining strap needs to be put over the cord before the plug is attached. How do you attach it for a replacement plug cover for an existing installation?
asked by: Geoff B
0
Product Page this Question was Asked From
Kat's Heaters Plug Cover for Power Cords with 3-Prong Plugs
- Accessories and Parts
- Vehicle Heaters
- Engine Block Heaters
- Engine Oil Heaters
- Plug Cover
- Kats Heaters
more information >
Continue Researching
- Shop: Kat's Heaters Plug Cover for Power Cords with 3-Prong Plugs
- Q&A: How To Install Kats Engine Block Heater KH97VR On 2024 Ford F-150
- Q&A: Is Silicone Dielectric Grease Needed When Installing A Kat's Heaters Engine Block Heater
- Q&A: How Does Brake Controller Install on Freightliner S2RV Chassis
- Q&A: Engine Block Heater for a 2016 GMC Canyon with 2.4L I4 or 3.6L V6 Engine
- Q&A: Where is The Wiring For Brake Controller On a 2019 Jayco Seneca Freightliner Chassis?
- Q&A: Will Tekonsha Brake Controller Wiring Harness 3027-P Fit a 2014 Freightliner XCS Chassis
- Q&A: How to Connect Prodigy P3 Wiring to a Renegade Valencia RV on Freightliner S2RV Chassis
- Article: Towing a Trailer? Let's Talk About Brake Controllers