How Does a Hose Get Glued into Valterra RV Sewer Termination Adapter T1029-2
Published 03/17/2017
Question:
How do you glue the hose to the connector? It doesnt appear to be smooth so I am not sure how this works.
asked by: Brian S
0
Expert Reply:
When gluing a new spigot or bayonet fitting use ABS glue. There should be plenty of surface area on the hose for the glue to work. You may have to bunch up the hose some if it doesn't have a what is essentially a collar at the end of the hose. If you have to do that then be sure to secure the bunched up hose after the glue has been applied and inserted in the connector so that it doesn't try to unfurl.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Valterra RV Sewer Termination Adapter - 3" Lug Fitting to 3" Hub
- RV Sewer Hose Fittings
- Sewer Adapters
- Termination Adapters
- Hub
- Lug
- Sewer Hose to Sewer Outlet
- 3 Inch Diameter
- 3 Inch Diameter
- Valterra
more information >
Continue Researching
- Shop: Towing Mirrors
- Q&A: Surge Protector for 2026 Thor Pasadena 34XG With 50A Service
- Q&A: Are the Valterra Waste Valves Directional as Far as Direction of Flow?
- Article: Converting Your RV Water Heater to Tankless
- Q&A: How To Determine If A Brake-Lite Relay Is Needed On My Flat Tow Setup
- Q&A: Is There An Adapter Avilable To Go From 3" PVC To A 3" Bayonet Fitting
- Q&A: Is There a Difference Between the Valterra Double RV Waste Valves and Bristol Double RV Waste Valves
- Q&A: Replacement Option For Norcold N306.3 RV Fridge
- Q&A: Location of the Electric Brake Control Harness on a 2012 Toyota Tacoma
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: How to Install an RV Awning From Scratch
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: The Ultimate RV Camping Checklist for Your First Year RVing