Installation Instructions and Hardware Recommendations for the Aluminum Ramp End # EM07200
Updated 01/19/2011 | Published 01/17/2011
Question:
Does this item include bolt, washer, and nut? If not, can you recommend the type to purchase? Thanks.
asked by: AJLEE
Expert Reply:
The Aluminum Ramp End for 2x8 Board, 750 lbs. (Qty 1), item # EM07200, does not include installation hardware. I would recommend using 3/8 inch carriage bolts, at least 1/2 inch longer that the board you will be using, and a washer and lock nut.
Place the part of the ramp end with the holes in it on the bottom of the board you plan to use and mark holes to drill. Then insert the carriage bolts from the top of the board and tighten the nut and washer on the bottom of the ramp end.
Product Page this Question was Asked From
Aluminum Ramp End for 2x8 Board, 750 lbs. - Qty 1
- ATV Ramps
- Single Ramp
- Ramp Ends
- 750 lbs
- For 2 x 8 Board
- Aluminum
- Erickson
more information >
Continue Researching
- Q&A: Where to Mount Ark Drop Down Corner RV Stabilizer Jacks
- Q&A: Weight of ARK AR34FR Drop Down RV Stabilizer Jacks
- Q&A: How many Boards Will The Ramp Kit For 2x8 Boards Complete One or Two
- Article: What To Look For When Buying Ratchet Straps
- Q&A: What Torque Rating Should the Lug Nuts of the Kenda Wheel and Tire Combo Be Tightened To
- Q&A: Lug Nut Torque to Use for Trailer Wheel Based on Stud Size
- Q&A: Torque Specs for 1/2 Inch Lug Nuts on a 15 Inch Steel Trailer Wheel
- Q&A: Dexter 10,000LB Axle Wheel Retaining Ring Placement
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Install E-Track in 3 Easy Steps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)