Recommendation to Extend Factory 7-Way to Fit with New Bumper on 2010 Ram 2500
Updated 02/24/2017 | Published 02/23/2017 >
Products Featured in This Question
Question:
I have a 2010 ram 2500 that I put a 2015 rear bumper on. The trailer wiring is on the right side vs left side on factory 2010. So what I need is a adapter that would extend the factory wiring about 12 inches, and retain the factory plug.
asked by: Kory
Expert Reply:
There are a couple of options to extend the factory wiring at the rear of your 2010 Ram 2500 so that it can reach the new connecter opening on the 2015 bumper.
The easiest solution is to use a 5th Wheel Wiring Harness like the Curt # C56070. This will plug in-line with your existing factory wiring and provide an extended harness on the other end. The only drawback on this option is that the Curt # C56070 represents the shortest 5th Wheel Harness that we offer at 7 feet long. So you will need to wrap up a decent amount of excess wire with some zip ties like # DW05727-25 after the necessary length is reached.
Another option is to use the Pollak Wiring Harness Extension # PK11-934. This is much shorter at 3 feet, but you will need to hardwire one end into a new connector like the Hopkins # HM48480. The other end will plug directly into your factory 7-way wiring harness.
Product Page this Question was Asked From
Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 7' Long
- Custom Fit Vehicle Wiring
- 5th Wheel and Gooseneck Wiring
- Vehicle End Connector
- 7 Blade
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Does Landing Gear Leg LC179013 Attach Directly to Motor
- Q&A: Is There a Downside to Using Offset Gooseneck Ball Compared to Non-Offset
- Q&A: Where Does The VELIT Portable Diesel Heater Get Fuel? Is There An Internal Gas Tank?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement for Atwood Heavy Duty MPD 86065
- Q&A: Recommended Gooseneck Hitch for a 2025 Ram 2500
- Q&A: Repair Kit for Ram Channel Tongue Coupler
- Q&A: Curt CrossWing or Sliding 5th Wheel Hitch for a 2021 Ram 2500
- Article: Trailer Wiring Diagrams
- Article: Ram Trailer Tow Prep Package
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Should You Add an Air Compressor to Your Air Bags?



