What Size are the Mounting Holes for Optronics LED Trailer Tail Light # STL68RB
Updated 01/24/2017 | Published 01/23/2017
Question:
What size screw would I use to mount these? I cant find that dimension anywhere. Thanks!
asked by: Andy
0
Expert Reply:
I went out to the warehouse and measured the mounting holes on trailer tail light # STL68RB for you. I used digital calipers and got a measurement of 0.20 inches which is in between 3/16 and 1/4 inch.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Fusion LED Trailer Tail Light - Stop, Tail, Turn, Backup - Submersible - Oval - Red/Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Stop
- Tail
- Turn
- Oval
- Surface Mount
- Submersible Lights
- LED Light
- 10L x 3W Inch
- Red
- White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Wiring Diagrams
- Q&A: What Hitch Weighs the Least for My 2025 Toyota RAV4 Hybrid Plug-In?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Comparing Fusion LED Trailer Tail Light STL68RP5B and STL68RB
- Q&A: Replacement Slam Latch For A Challenger Nova Baggage Door Latch
- Article: Trailer Lighting Requirements
- Q&A: Replacement Fender for Yacht Club Jet Ski Trailer Measuring 20.5 Inches Between Mounting Holes
- Q&A: Is Additional Part Necessary to Prevent Breakaway Battery From Draining?
- Q&A: What Surge Coupler is on Military M1102 MCC Trailer
- Q&A: Wedge Style Latches Vs. Trigger Latches on A-Frame Couplers
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)