Rear Suspension Enhancement Recommendation for a 1995 Toyota Tacoma

Question

Question:

1995 Toyota Tacoma Xtra Cab 4x4 with an 800lb Four Wheel Camper in the bed. 243K miles on the original suspension....an extra leaf spring, too. I put new stock shocks on 2 years ago. I live in the mountains and will be doing a lot of back country roads along with highway miles. Which application would be ideal for my rear suspension..Timbrens or Super Springs? Camper will be on 24-7! Thanks

asked by: Lance

0

Expert Reply:

For your application with an extra leaf spring already installed on the 1995 Toyota Tacoma, I would go with the Timbren Rear Suspension Enhancement System, # TTORTAC4A. It will not affect the empty ride of the vehicle, the springs get more rigid under load for more support, they are easy to install, and they are very cost effective. Since you will be on a lot of back roads, the added bonus of these springs acting as additional shocks will help out with ride quality as well.

I have included a link to the installation details below. In the event that the extra leaf spring you added interferes with installation, it will have to be removed, however, these springs do have a capacity of up to 3,600 pounds which should compensate for the removed leaf spring.

expert reply by: Michael H

0

Answer 1

The Timbren Suspension Enhancement System #TDVR05091 is designed to bolt right onto your 1994 Toyota pickup. This will replace your truck's current bump stop by bolting to the frame in the same location. You should know that the Timbrens are to…

view full answer...

Answer 2

The helper springs in Timbren kit #TTORTAC4A are 5-1/8 inches tall by themselves. The overall height of the whole assembly will be a little taller. Does your 2004 Toyota Tacoma have a suspension lift?

view full answer...

Answer 3

I do have an option for you but we don't offer air bags for a 1991 Toyota Pickup. Instead, I recommend upgraded jounce bumpers like the Timbren Rear Suspension Enhancement System part #TTORTAC4A which offers a bolt-on fit and works well to reduce…

view full answer...

Answer 4

Due to the design of the Timbren Rear Suspension Enhancement System #TTORTAC4A on your 2002 Toyota Tacoma the screw that would normally sit in that position is welded on as you do not have access to the head of the screw when it is installed on your…

view full answer...

Answer 5

Timbren does make spacers like the part #A25723-90AH00 for a 1 inch spacer and #TA25722-90P00 for a 1/2 inch spacer which you can use to take up extra space created by lift kits so that you can still use their suspension enhancement kits like the…

view full answer...

Answer 6

I reached out to my contact at Timbren and the Timbren Rear Suspension Enhancement System #TTORTAC4A you were looking at for your 2000 Toyota Tacoma will not hardly compress at all until you reach 4800lbs on the rear suspension. After 4800lbs you…

view full answer...

Answer 7

The Timbren kit part #TTORTAC4A would be what you would need.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 12

Hey Fernando, I'd be happy to help you pick out the correct Timbren rear suspension kit for your 2023 Toyota Tacoma TRD that will be towing a trailer. Really it comes down to two options. You would want the part #TTORTUN4L for if you have the 3…

view full answer...

Rear Suspension Enhancement Recommendation for a 1995 Toyota Tacoma

Products Featured in This Question

Continue Researching