Can the Bulb in Trailer Stop, Turn and Tail Light ST8RB Be Easily Replaced
Updated 11/23/2010 | Published 11/22/2010
Question:
the original strongbox trailer tail light has a socket that is impossible to remove and replace the bulb. is the optronics fixture the same or a better designed bulb socket?
asked by: Bill M
0
Expert Reply:
The bulb # ST8RB trailer tail light can definitely be replaced, and to do so is not difficult. The face of the light taken off by removing four small screws, and once this is done you have access to the bulb socket and can proceed with changing the bulb.
The replacement bulb for this light would be part # A1157B.
expert reply by:
Sarah L
0
Product Page this Question was Asked From
Optronics Combination Trailer Tail Light - 6 Function - Incandescent - Red Lens - Passenger Side
- Trailer Lights
- Tail Lights
- Rear Reflector
- Side Marker
- Side Reflector
- Stop
- Tail
- Turn
- Square
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 5-5/16L x 4-9/16W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Replacement Spring Loaded Jack For A Binkley 48000 SL
- Q&A: Looking For Replacement 7-Way Plug With Double Prong Design
- Q&A: How Do The Mounting Holes On The Demco Coupler DM14040-81 Measure?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Circuit Configuration in RV-Type 7-Way Trailer Wiring
- Q&A: How To Tell If I Have An EZ Lube Axle
- Q&A: Recommended Spare Hub for TDE 3,750 Lb Axle
- Q&A: Replacement Brake Caliper for a 12K AL-KO Axle
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Lighting Requirements
- Article: How to Replace or Install an RV Roof Vent