Bearing Buddy Recommendation to Replace Dust Cap that Measures 1.964 inches
Published 11/02/2016
Question:
trying to figure out what size bearing buddy to get for my utility trailer. I measured the dust cap. With digital calipers it is 1.917 to the inside wall and to the outside of the wall it is 1.964 and when I eyball it with a tape measure it appears to be 1 15/16 1.9375. Im assuming the correct fit will be the 1938 but the 1968 seems close too. It is a Carry-On Trailer utility landscape was built on April 20, 2011. GVWR is 1356 KG2990 LB and is the 5x8 GW. Any and all help would be appreciated. Thank you.
asked by: Jim P
Expert Reply:
The closest Bearing Buddy we offer which would be a fit is the part # BB1968. This fits the outside diameter of the cap you mentioned as it measures 1.968 inches.
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1968 - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.96 Inch
- 2000 lbs Axle
- 3500 lbs Axle
- Bearing Buddy
more information >
Continue Researching
- Q&A: What is Next Size Smaller Bearing Buddy than One with 1.98 inch Outer Diameter
- Q&A: Replacement Actuator for a TDE Model LP7000
- Q&A: Bearing Buddy Recommendation for Hub Bore of 1.97 inches
- Q&A: How To Tell What Size Bearing Buddy Is Needed for My Trailer Hubs
- Article: Most Popular Wheel Bearings
- Q&A: Solution for Needing Replacement Tie Down LP70 Actuator
- Q&A: What Is The Difference Between A Disc Brake and Drum Brake Surge Brake Actuator?
- Q&A: Replacement Winch Recommendation for Fulton T3205 that is Discontinued
- Article: Where to Position the Trailer Axle?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)