Thickness of the Aluminum of the Jeep Fender HP96VR
Published 11/01/2016
Question:
What thickness material not including the raise of the diamonds is this fender fabricated of please?
asked by: JB
0
Expert Reply:
I went out to the warehouse to measure an Aluminum Tread Plate, Jeep-Style, Single-Axle Trailer Fender, # HP96VR. The aluminum is just over 1/16 of an inch thick (0.065 inches).
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" - Qty 1
- Trailer Fenders
- No Step
- 13 Inch Wheels
- 14 Inch Wheels
- 15 Inch Wheels
- 10 Inch Wide
- 33 Inch Long
- Aluminum
- Bolt-On
- Weld-On
- For Single-Axle Trailers
- Diamond Plate
- etrailer
more information >
Continue Researching
- Q&A: What is Weight Rating for the CE Smith Safety Chains # CES82QR
- Q&A: What Fender Do I Need for a Utility Trailer w/ 205/75 D15 Tires?
- Q&A: Looking For Guide Posts With Trailer Tail Lights That Go On Top
- Q&A: Correct Hubs/Drums and Brakes for an Axis 3,500 Lb Trailer Axle
- Q&A: Power Consumption for 4.3 cu. ft. Furrion Arctic RV Refrigerator
- Q&A: How to Pick Out Replacement Cable Length for Trailer Torsion Ramp Spring
- Q&A: How To Install a Battery On a Trailer for Use with Electric Jack
- Article: Best Boat Trailer Jacks
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Snow Tire Chains Explained: How Tire Chains Work & When to Use Them