Diameter of the 1/2" Diameter Greasable Hinge Pin
Published 09/15/2016
Question:
HI THERE IHAVE A QUESTION ABOUT YOUR BULLET HINGES FIRST HOW ARE THEY MEASURED ID/ OR OD? 2HOW ARE THEY SOLD THESE ARE THE WELD ON BULLET HINGES WITH GREASE FITTING THAT I AM REFERRING TO .
asked by: Steve
0
Expert Reply:
The part # HP12412G is 4-3/4 inches long overall not including the grease fitting. The outside diameter is 3/4 inches. That is the portion of the hinge that gets welded to a trailer. The inner portion that inserts into the other part of the hinge is 1/2 inch.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
1/2" Diameter Greasable Hinge Pin, 4-3/4" Long with 3/4" Base
- Accessories and Parts
- Trailer Door Hinges
- Trailer Door Parts
- Hinge Pins
- Redline
more information >
Continue Researching
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Does Towing Two Trailers Require Two Brake Controllers
- Q&A: Recommended Gate/Ramp Assist and Hinge for Trailer Build
- Q&A: How is Pin of Trailer Barrel Hinge Secured
- Q&A: Trailer Brakes Lock Up When Connected to Truck
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Brake Assemblies for Dexter 023-358-00 Trailer Brakes
- Article: Best Bike Racks for Electric Bikes
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Maintenance Schedule
- Article: Double-Eye Trailer Suspension System Review