Does Zerk Fitting of EZ Lube Spindle Need to be Removed to Install Bearing Buddy
Updated 08/30/2016 | Published 08/29/2016
Question:
I have ez lube spindles. Do I remove the zerk fitting on the end of the spindle before attaching the bearing buddy?
asked by: Bill
0
Expert Reply:
Yes, you will need to remove the zerk fitting of your EZ lube spindle to be able to install a Bearing Buddy.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 2441 - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 2.44 Inch
- 4400 lbs Axle
- 5200 lbs Axle
- 6000 lbs Axle
- 7000 lbs Axle
- Bearing Buddy
more information >
Continue Researching
- Q&A: What Lock Kit Is Needed For My B&W Pintle Hitch?
- Q&A: Looking for Brake Line Kit that Fits TA96BT 23-27 EZLoader Boat Trailer
- Q&A: Semi Trailer Light Function Locations on Heavy Duty 7-Way Pin Connection
- Q&A: Installation of Emergency Break Away Cable Repair Kit for Dexter Axle A-60 Brake Actuators
- Article: Most Popular Wheel Bearings
- Q&A: What Size Bearing Buddy to Replace 2-7/16-Inch Grease Cap
- Q&A: Are Bearings 15123 and LM67048 the Same
- Q&A: Replacement Disc Brakes, Bearings, and Actuator for 2010 EZ Loader Boat Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Bleed Your Trailer Surge Brakes
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?