Will 4-Pole Trailer Connector Carry Signal for Hazard Lights
Published 07/26/2016
Question:
on a 4 wire flat connection, does the trailer have hazard lights that work when my truck hazard lights are on?
asked by: Gary M
0
Expert Reply:
The signal for the hazards is carried on the right and left turn circuit, which is the green and yellow wires on the 4-pole flat. When the vehicle hazards are switched on, the hazards on the trailer will flash as well.
If you click the provided link, you can see our trailer wiring FAQ article, which you might find helpful.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Curt 2-to-3 Tail Light Converter for Towed Vehicles w/ Incandescent Tail Lights
- Flat Tow Wiring Harness
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal Fit
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Where to Mount the 6-Way Bracket on the etrailer Invisible Base Plate Kit e44FV
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Drum do I Need to Replace My Lippert Drum with 696690 Stamped on it?
- Q&A: Which Pin of Blue Ox 6-Way to 7-Way is for 12 Volt Charge Circuit
- Q&A: Will Pollak 7-Way Socket Fit with Blue Ox 7-Wire to 6-Wire, Coiled Electrical Cord
- Q&A: How to Separate Out Brake and Turn Signals for LED Lighting Underneath Trailer
- Q&A: Buzzing Noise from Vehicle to Vehicle Tail Light Converter Part # C56196
- Q&A: Looking for Hitch that Fits 2007 Volvo S80
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Choose a High-Low Adapter
- Article: Curt Echo Full Review
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)