Can Pre-Drilled Round Rubber Bumper - 2 inch x 96 inch be Cut to Fit the Width of 60 inch Trailer
Published 09/23/2010
Question:
Can this bumper be cut to length. My trailer ramp is about 60 inches? Thanks
asked by: Stephen W
0
Expert Reply:
Yes, the Pre-Drilled Round Rubber Bumper - 2 inch x 96 inch part #, D2-96 can be cut down to fit any application you may have.
After going out into the warehouse and looking at the bumper I recommend either using a utility knife to very carefully cut it, or securing the rubber tightly and using a sawz-all to make the cut.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pre-Drilled Round Rubber Trailer Bumper - 96" Long x 2-1/16" Wide
- Trailer Door Parts
- Ramp Door Bumpers
- Bumper Strip
- Bolt-On
- 2-1/16 Inch Wide
- 96 Inch Long
- Rubber
- Redline
more information >
Continue Researching
- Q&A: What hardware is used to attach the 96inch predrilled rubber bumpers?
- Q&A: Coupler Repair Kit for the Bulldog Gooseneck Coupler 028900
- Q&A: Replacement for 84 Inch Bumper on Horse Trailer
- Q&A: Center To Center Hole Spacing on Redline # D2-96 Rubber Bumpers
- Q&A: Round Rubber Horse Trailer Bumper Guard Needed That's 84" Long
- Q&A: Air Force One Air Jumper Kit For Spartan K2 Chassis.
- Q&A: What Direction Should The Band on a Leaf Springs Be Faceing
- Article: Most Popular Wheel Bearings
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: VCC Pickup and Dropoff
- Article: Trailer Maintenance Schedule
- Article: Slipper Spring Trailer Suspension System Review
- Article: Truck Bed Bike Rack Systems
- Article: Determining Trailer Tongue Weight