How to Remove the Knob on a Raptor Aero Bike Rack to Install a Replacement Knob
Updated 06/23/2016 | Published 06/21/2016
Question:
Is there any directions on how to install. I cant figure out how to get my old one off?
asked by: Scott
0
Expert Reply:
To get the old knob off of your Raptor Aero Y02093 first tighten it until the opposite end sticks out of the claw. On that end there is a little clip. Use a small screwdriver or a pocket knife to gently pry the clip off. Then all you have to do is loosen the knob until it comes out. To install the new knob simply reverse the process. When it comes time to put the clip back on use a coin or a key to push it on.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Replacement Locking Knob Assembly for Yakima Raptor Aero Roof Mounted Bike Carrier
- Accessories and Parts
- Roof Bike Racks
- Knobs
- Raptor
- Yakima
more information >
Continue Researching
- Q&A: Looking For Replacement Parts For A Yakima Raptor Aero Rooftop Bike Rack
- Q&A: Replacement Jaw Pad for Yakima Raptor Roof Mounted Bike Rack
- Q&A: Replacement Bolt And Knob Option For An Older Bauer Bicycle Rack
- Q&A: How To Determine the Correct Replacement Knob for a Yakima Frontloader
- Q&A: Thread Size of Replacement Handle with Nut for Yakima FullSwing and SwingDaddy Bike Racks Y8890308
- Q&A: Dimension of Yakima Replacement Hardware and Clamp Y8880192
- Q&A: Fixing the Spinning SpeedKnob on Yakima Ridgeback