Roller Bunks And Brackets That Can Be Angled To Fit V-Bottom Boat
Published 06/14/2016
Question:
Can these brackets be used with the Dutton-Laison roller bunks. In your video of the roller bunks it shows a flat-bottom boat and the brackets that are recommended are straight. My V-bottom boat will require an angled bracket, will these work for me? If these will not work what would you recommend.
asked by: Reggie
Expert Reply:
To be able to mount roller bunks to your trailer and allow them to be angled to match the hull of your boat there are rollers and brackets that will work for you.
You will need to use the Dutton-Lainson Boat Trailer Standard Roller Bunk, part # DL21755. These are black rollers that are 5-ft long. There are 12 sets of 2 rollers with this set.
The brackets that can be used with these rollers is part # DL21762. Four brackets are needed for a pair of roller bunks.
Product Page this Question was Asked From
Boat Trailer Roller Bunk Bracket for Dutton-Lainson Roller Bunks Parts DL21754 & DL21755
- Boat Trailer Parts
- Bunks
- Roller Bunk Bracket
- Zinc-Plated Steel
- 10-3/4 Inch Long
- Dutton-Lainson
more information >
Continue Researching
- Q&A: Looking for 9" Wide Rollers and Brackets for a Holsclaw Boat Trailer
- Q&A: Availability of 6' Long Roller Bunks
- Article: The Basics of Boat Trailer Bunks: Bunks or Rollers?
- Q&A: Recommended Wood for Bunk Boards on Boat Trailer
- Q&A: Can I Use Roller Bunks and Carpeted Bunk Boards Together on Boat Trailer
- Q&A: Should There Be a Washer Between Outer Bearing and Castle Nut on etrailer 2,000 lb Trailer Axle
- Q&A: Replacement Carbon Monoxide Detector for Atwood 36681
- Q&A: Replacement Bearing and Seal Kit with Grease for a Malone MicroSport Trailer
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Install E-Track in 3 Easy Steps
- Article: Best Running Boards