Installing Swagman Truck-Bed-Mounted Bike Carrier S64702 in 2004 Toyota Tacoma with Bed Liner

Updated 05/25/2016 | Published 05/24/2016

Products Featured in This Question

Swagman Truck Bed Bike Rack for 2 Bikes - Fork Mount - 9-mm Skewer

(273)

$163.23

Loctite RTV 598 High-Performance Silicone Gasket Maker - Black - 2.7-Fl Oz Tube

(190)

$9.55

Question:

Just received the product today from your store. thank you. i have a question regarding not using the provided end plate pin photo attached for the reason that i do not want to drill a hole on my bed liner. can i not use the end plate pin? thanks.

asked by: Lorenzo Q

Expert Reply:

When the Swagman Pick-Up Truck-Bed-Mounted 2 Bike Carrier # S64702 is installed in a truck with a drop-in bed liner, like your 2004 Tacoma, the two included end plate pins (with Philips head) must be used to prevent the rubber end pads from slipping on the bed liner's surface. I do understand that you'd prefer not to drill any holes in your liner, but in this instance this installation step is required for your truck.

You can use a silicone sealer like # LT37467 to seal the screws/holes after you install the rack to prevent moisture from entering. Or if you remove the rack in winter months you can seal up the two holes and then easily remove that silicone material when springtime arrives and the rack needs to go back on the truck.

expert reply by: Adam R