Do both Sections of the Andersen Camper Wheel Chock part # AM3604 Need to Be Cut if One Does
Updated 05/23/2016 | Published 05/17/2016
Question:
There isnt a lot of space between my tires. If I cut one leveler do I have to cut the other one to make the same? Advice please?
asked by: René B
0
Expert Reply:
If you needed to cut the longer section of the Andersen Camper Wheel Chock part # AM3604 to allow the section to fit between your tandem setup you wouldn't have to cut the second section as well. The smaller piece that wedges underneath the would not have to be cut to fit since it is already smaller.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Andersen Camper Wheel Chock and Leveler
- Wheel Chocks
- Wheel Chock
- RV
- Trailer
- Plastic
- Smooth Surface
- 1 Chock
- Red
- Andersen
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Weight Distribution System And Brake Controller For Towing A 2022 Forest River No Boundaries NB19.2
- Q&A: Should Weigh Safe Leveling Kit with Wheel Chocks Sit Under All Four Tires
- Q&A: Will B and W Fifth Wheel to Gooseneck Adapter Void Lippert Frame Warranty
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
- Q&A: Will Storing Trailer on Grass/Dirt Damage Trailer Tires
- Q&A: How To Determine If Andersen Rapid Jack or Blaylock EZ Jack Will Lift Enough to Remove Wheel
- Q&A: Recommended Electric A-Frame Jack w/a Tongue Weight Scale
- Article: How to Level a Travel Trailer in 3 Steps
- Article: How to Measure for Trailer Hitch Drop
- Article: Still Rocking After Leveling? How to Stabilize Your RV for Good
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: Determining Trailer Tongue Weight
- Article: The Best Electric Trailer Jacks of 2025