Option for Raising Hitch Opening for Adding Ground Clearance to Cargo Carrier
Updated 04/11/2016 | Published 04/07/2016
Question:
My handicap chair, hove round cage drags ground in low spots , I need to raise hitch point about 3 to 4 inches to stop dragging, any suggestions.
asked by: Herman H
0
Expert Reply:
The Curt ball mount part # D210 has a hitch opening that is 3-9/16 inches above the shank that slides in the hitch. What's nice about this adapter is that it doesn't reduce the capacity of the hitch it is installed on by 50 percent like most high-low adapters.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Multipurpose Ball Mount with 2" Receiver for Bike Racks and Cargo Carriers - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank
- Drop - 2 Inch
- Rise - 0 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How do I use a Bike Rack and Pull a Trailer at the same time
- Q&A: Do Gaps Need to Get Filled When Installing Blue Ox Hitch BLU72UR
- Q&A: Can I Tow a 7,000 lb Horse Trailer With the Roadmaster Dual Receiver Hitch Adapter?
- Q&A: Roadmaster Hitch Extender Clearance for Flat Towing with Bike Rack
- Q&A: Will the etrailer Electric Trailer Jack e23ZV Work w/a Jack-It Bike Rack?
- Q&A: High Capacity Dual Hitch Receiver With Capacity Greater Than 5,000lbs
- Q&A: Does etrailer Base Plate Kit for 2025 Ford Maverick Lariat Require ACC Sensor
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Anti-Rattle Devices
- Article: How to Tie Down Luggage on a Roof Rack
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring