Wheel Stud Size and Replacements for Dexter Trailer Hub Assembly 8-214-5
Updated 04/04/2016 | Published 03/31/2016
Products Featured in This Question
Question:
What are the studs that go into the hub and can I get them separately?
asked by: Jim M
0
Expert Reply:
Trailer Hub Assembly # 8-214-5 comes with 5/8 inch diameter drive-in studs. These are available separately in a set of 4, # RG03-120.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Trailer Idler Hub Assembly for 10,000-lb Axles - 8 on 6-1/2
- Trailer Hubs and Drums
- Idler Hub
- Standard
- 395S / 387A
- Standard Grade
- For 10000 lbs Axles
- 5/8 Inch Stud
- 8 on 6-1/2 Inch
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- 17-1/2 Inch Wheel
- Dexter
more information >
Continue Researching
- Search Results: 95188
- Search Results: bp01~301
- Search Results: timken bearing kit
- Search Results: spindle washer
- Search Results: alko
- Search Results: dexter magnet
- Search Results: 387a
- Shop: Replacement Trailer Hub Wheel Stud, Drive-In, 5/8" x 3-1/8" (Qty 4)
- Shop: Flange Wheel Nut - 5/8"
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: Can Dual Wheels On 10K Dexter Axles Be Changed Over To Super Single 17.5" Wheels and Tires?
- Q&A: Torque Specification for Lugs Nuts on 5/8-Inch Stud on Dexter Hub
- Q&A: What Would Need to Change to Go from Single Wheel Axle on Trailer to Dually
- Q&A: Hub Bore Diameter of etrailer.com Trailer Idler Hub Assembly # AKIHUB-545-2-G-2K
- Q&A: Length of Spline Section of Replacement Trailer Hub Wheel Stud
- Shop: Hub-Piloted Steel Wheel w -0.5" Offset - 17-1/2" x 6-3/4" - 8 on 6-1/2 - Gray
- Shop: Taskmaster Solid Center Wheel w/ -0.19 Offset - 17-1/2" x 6-3/4" Rim - 8 on 6-1/2 - Silver
- Shop: etrailer Electric Trailer Brakes w/ Dust Shields - Self-Adjusting - 12-1/4" - Left/Right - 10K
- Shop: Replacement Trailer Hub Bearing - 387A
- Shop: Taskmaster Solid Center Wheel w/ -0.31 Offset - 17-1/2" x 6-3/4" Rim - 8 on 6-1/2 - Silver
- Video: The Low-Down on the Replacement Trailer Hub Wheel Stud, Drive-In, 5/8" x 3-1/8" (Qty 4)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Video: All About the Grease Seal
- Q&A: Availability of 5/8 Inch Flange Nut