Troubleshooting Clicking Landing Gear on RV After New Landing Gear Motor
Updated 03/23/2016 | Published 03/21/2016
Question:
I have a question I have replaced the motor on my landing gear and the new motor does the same loud clicking noise I have the new gear reduction box just have not put it on yet.any advise
asked by: Brian B
0
Expert Reply:
The load clicking is most likely an insufficient ground for the landing gear motor or that the amperage draw for the landing gear is greater than what the power source can handle. Or it is that you are overloading the weight capacity of the landing gear.
Most likely it's just a bad ground though.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Stromberg Carlson
more information >
Continue Researching
- Search Results: landing gear motor
- Shop: Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Shop: Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor
- Q&A: Landing Gear Moving In Opposite Directions When Switch Is Activated
- Q&A: Troubleshooting Clicking Noise Coming From Landing Gear or Motor
- Q&A: Troubleshooting Landing Gear Operating Backwards After Installing New Switch
- Q&A: Replacement Landing Gear Motor for a ADTH E226168
- Q&A: Replacement Landing Gear Motor for a 8532-07 Motor
- Q&A: Replacement Atwood 75722 Motor for Atwood Camper Jack
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Converting Your RV Water Heater to Tankless
- Article: Best Landing Gear
- Article: How to Mount a Truck Bed Camper
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups