How to Determine if the Fulton Swivel Marine Jack JXP10W0301 Will Fit a Trailer  

The correct replacement for the Fulton Magnum Series Trailer Jack on your trailer is the Fulton Bolt-Thru Swivel Marine Jack part #FXP10W0301 if you have a bolt-thru mounting bracket or part #FTJ120W0301 if you have a snap-ring mounting bracket. I…

What we have heard is that the Fulton #FTJ120W0301 does fit the mounting plate of the Shelby Jack 5784. This will be your best option. This jack has a 1,200 lb lifting capacity which would be more than enough.

The Fulton Bolt-Thru Swivel Marine Jack, Weld-On #FXP15W is designed to mount to its mounting bracket with a single center bolt. The mounting bracket designed to work with this jack is part #P9012-00. In order to replace the weld-on jack on your boat…

The Fulton Jacks that have the 3"x5.5" bolt pattern are typically the center bolt thru style. For a replacement the Fulton Bolt-Thru Swivel Marine Jack part #F1411300301 is an excellent choice. It will replace the jack only portion of your…

I contacted our representative at Fulton about the Fulton Round, Snap-Ring Swivel Marine Jack, part #FTJ120W0301. The inner diameter of the mounting hole is 2-1/2 inches. He informed me that up to a few years ago the Fulton jacks were made in…

What we have heard is that the Fulton #FTJ120W0301 does fit the mounting plate of the Shelby Jacks like what you have. This would be our best option.

As long as your current bracket measures 2-1/8" from the center of the bolt to one of the pin holes then the Fulton Bolt-Thru Swivel Marine Jack #FXP10W0301 will work great as a replacement for your Shelby 5784 bolt-thru jack.

What we have heard is that the Fulton #FTJ120W0301 does fit the mounting plate of the Shelby Jack 5784.

I can't see any part numbers or manufacturer names from your picture, but the Fulton XLT #F141132 does look very similar. I went out to the warehouse and measured the bracket that the bolt, washer, and nut go through for the installation. The…

Then that means you're looking for the Fulton Bolt-Thru Swivel Marine Jack with Dual Wheels #F27CR. We use different part numbers on our site compared to the manufacturers, but this is the exact trailer jack you're wanting. Attached is a…

The bolts used in the mounting hardware for the Fulton Bolt-Thru Swivel Marine Jack with Dual Wheels #F27CR measure 3/8-16 X 4.0" so the lock nuts will be 3/8-16, and then these are 5 Grade bolts. Attached is a review video for you to check…

We aren't going to have a jack that's going to bolt right up to the same mounting bracket your Shelby mounted to so your best option will be to cut off the old mounting bracket and weld on a new one like with what you could do with the Fulton…