Mounting Bracket for a 4- or 7-Way Trailer Connector on a 2013 Nissan Xterra
Published 02/03/2016
Products Featured in This Question
Question:
Is there a housing or adapter that can be attached to the receiver so the wires are protected and not just hanging there, other than just the clip that you can attach from the wires to the receiver
asked by: Gordon
Expert Reply:
Yes, you can attach a mounting bracket to the hitch on your 2013 Nissan Xterra to hold a trailer connector. For a 4-Way flat connector such as # C56225, you can use bracket # 18144 and attach it to bracket # 18140 which will then attach to the hitch.
If you have a 7-Way such as # 118266 then you can use bracket # PK12711U with # 18140.
Nothing should be drilled into or welded directly to the hitch.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Hitch and Wiring for 2023 Nissan Frontier Without Tow Package
- Q&A: Should I Beef Up the Suspension On a 2006 Nissan Xterra When Towing a Trailer
- Q&A: Recommended Weight Distribution System For 2010 Nissan Xterra And StarCraft RT11 Pop-Up Camper
- Q&A: Load Rating For SumoSprings Solo Custom Helper Springs On 2010 Nissan Xterra
- Q&A: Everything Needed to tow Travel Trailer With 2012 Nissan Xterra
- Q&A: Trailer Brakes Lock Up when Trailer is Plugged into 2015 Nissan Xterra
- Q&A: Should Trailer Wiring Be Stored Inside Vehicle When Not in Use
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)