How Could a Pulley Block Be Used to Slow Down Plow Blade From Raising and Lowering
Updated 01/27/2016 | Published 01/26/2016 >
Products Featured in This Question
Question:
Some users said that you could use a syntectic 10` to use with the winch and snow plow and set it up with pulleys to lower the speed and stress on the rope and the winch. Is this something that I could do? If this is possible how do I set up the pulleys?
asked by: Ed
Expert Reply:
A pulley block like the part # BDW20005 will reduce the speed of a winch by 50 percent when used.
I attached a picture that shows how one normally gets used in a more traditional application. Basically you attach the pulley block to the object that is getting moved (in your case the plow blade), and then you route the cable through it and back to the same area as where the winch is installed. This slows the pulley down and also increases capacity.
We don't have a specific recommendation on how to make this work for your application, but with what I listed you should be able to look at your setup and see how you could make this type of setup work.
Product Page this Question was Asked From
Superwinch LT3000 ATV Winch - Wire Rope - Roller Fairlead - 3,000 lbs
- Electric Winch
- ATV - UTV Winch
- Planetary Gear
- 1.0 HP
- 2001 - 4000 lbs
- 11 - 20 lbs
- Slow - 0 to 4 fpm
- Wired Remote
- Wire Rope
- Superwinch
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Solution for Replacement Winch for Old Starcraft Lift System
- Q&A: Locating the Brake Controller Connector on a 2017 Ford F-150 to Install the Hopkins # HM47294
- Q&A: Replacement Shelby 5438 Winch Recommendation for Pop Up Camper
- Q&A: Winch Recommendation for Pulling Racecar Up Into Trailer
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Article: How to Install E-Track in 3 Easy Steps
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Q&A: No Power At Brake Controller On 2007 Chevy Silverado Classic
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper


