Troubleshooting Trailer Blinker that Blinks Dimly When Opposite Turn Signal is Activated
Published 01/13/2016
Question:
When you cut on the left turn signal right turn signal blink dimly
asked by: James
0
Expert Reply:
What you are describing is typically caused by an insufficient ground. Check to make sure both of the blinker taillight assemblies are making a solid connection to either a metal portion of the frame or to a ground wire for the trailer.
You can also try running a jumper wire back up to the main ground circuit of the trailer harness as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailers Right Tail Light Stays on Even While Unplugged
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Q&A: Recommended Warm White 4-1/4" Diameter Puck Light
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can I Use a 4 Way Vehicle Connector with 7 Way Adapter and the Curt Echo Brake Controller?
- Q&A: Will Timbren's Work with a B&W Gooseneck Hitch on a 2012 Ford F-150
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer