Mounting Bracket Dimensions of the Flexco Manual Pull-Out Step SMFP-1100
Updated 12/28/2015 | Published 12/25/2015
Question:
What us the measurement on the piece that is attached to the trailer ?
asked by: Pamela P
0
Expert Reply:
The mounting bracket portion of the Pull Out Steps part # SMFP-1100 that you referenced is 6 inches long with a distance of 4-1/2 inches between mounting holes.
From outside to outside of each bracket it measures 25 inches. From bolt hole center to bolt hole center it measures 23-1/4 inches.
I attached a picture that has these dimensions and a few others for you to check out as well.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Flexco Manual Pull-Out Step for RVs - Single - 7" Drop/Rise - 24" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 25 Inch Wide
- 1 Step
- 7-1/2 Inch Drop/Rise
- 15 Inch Entry
- 16 Inch Entry
- 17 Inch Entry
- Steel
- Stromberg Carlson
more information >
Continue Researching
- Article: How to Measure for Motorhome Steps
- Q&A: Dimension of Flexco Manual Step # SMFP-1100 When Folded In
- Q&A: Can RV Steps be Installed on 2020 Nissan NV2500
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Trailer Wiring Diagrams
- Q&A: Curt item # C15845 Dimensions
- Q&A: Recommended Replacement RV Stereo for Jensen Voyager AWM900
- Q&A: How to Choose the Correct Ramp Spring for a Trailer
- Q&A: Replacement Hub for Trailer with 84 Spindle Dimensions
- Q&A: Recommended Installation Hardware for the Flexco Manual Pull Out Step
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Trailer Maintenance Schedule
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure for Trailer Hitch Drop