Installation of Curt Class III Trailer Hitch Receiver Part # 13329 on 2005 to 2010 Dodge Dakota
Updated 06/29/2010 | Published 06/27/2010
Question:
How do you install this part
asked by: Greg
0
Expert Reply:
The installation is pretty simple. One bolt passes through the bumper through the trailer ball hole plug located in the center of the bumper under the license plate area. The other two bolts attach the hitch to the bumper support.
I will provide a link to the install instructions for your review.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 5500 lbs WD GTW
- 2 Inch Hitch
- 550 lbs WD TW
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Installation Hardware for etrailer Scissor Stabilizer Jacks e36VV
- Q&A: Torque of Curt Trailer Hitch on 2010 Dodge Dakota
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Is The Mopar Recreational Flat Tow Wiring Kit Part 68321424AB Required To Flat-Tow a Jeep Cherokee
- Q&A: Trailer Hitch Recommendation for 2011 Ram Dakota
- Q&A: Is The Bulldog Trailer Jack # BD178201 Available
- Article: What Do I Need To Tow A Trailer?
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Recommended Trailer Hitch Receiver for a 2005 Dodge Dakota
- Q&A: Will Curt Hitch Fit with Bumper Hitch Ball Removed From 2007 Dodge Dakota
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams