Could the Erickson Ramp EM07464-2 Be Used on a Van for Loading Pressure Washer
Published 10/29/2015
Question:
The car thats gonna roll it in will be a 2003 Chevrolet Express Van. Usually lift it in there with two guys, but wondering if this will support and wont slide when putting it in.
asked by: Yong P
Expert Reply:
As long as there is a decent ledge at the rear of your 2003 Chevy Express Van when the rear door is open the ramps part # EM07464-2 that you referenced would not slide or move while pushing up your pressure washer that is on wheels.
I attached a picture that shows the brackets of the ramps that will rest on the rear cargo area of your van for you to check out. You will want to open the rear door of your van to see if the ramps would fit. Normally these ramps are used on truck tailgate so we do not have fit info for your van.
Product Page this Question was Asked From
Erickson Arched Loading Ramp Set - Center Fold - Steel - 80" Long x 11" Wide - 1,600 lbs
- ATV Ramps
- Ramp Set
- Center-Fold
- 11 Inch Wide
- 1600 lbs
- Arched
- 80 Inch Long
- Steel
- Erickson
more information >
Continue Researching
- Q&A: What is the Spacing Between the Rungs on the Stallion Loading Ramp Set # 288-07489
- Q&A: Is The 3 Rung Spacing On The Loading Ramp Too Wide For My Gravely Pro Turn ZX With 48 Deck
- Q&A: Extra Long Weight Distribution Hitch to Tow Travel Trailer with Truck's Tail Gate Down
- Q&A: How To Haul an ATV In Truck Bed While Towing
- Q&A: Can Oil Bath Trailer Hub Easily be Converted to Grease
- Q&A: How Often Should Oil in Trailer Oil Bath Hubs be Changed
- Q&A: Recommended Tarp For Protecting a 6' X 14" Double Axle Utility Trailer
- Article: Best Bike Racks for Electric Bikes