Dimensions Of Mounting Bracket For Stromberg-Carlson RV Ladder Support Peg
Updated 10/20/2015 | Published 10/19/2015
Products Featured in This Question
Question:
On the 501l and the la401 ladders, what is the measurements for the bolt holes on the support pegs ?
asked by: Brent K
0
Expert Reply:
I went to the warehouse and pulled one of the support pegs, part # 8535. I took some measurements of the bracket used to mount the support pegs and they are shown in the attached photo.
The bracket outside dimensions are 2-1/4 inches x 1-1/4 inch. The distance from the mounting holes center-to-center are 13/16 inches and 1-3/4 inches.
expert reply by:
Jeffrey L
0
click to enlarge
Product Page this Question was Asked From
Stromberg Carlson RV Exterior Ladder - Aluminum - 99-1/2" Tall - 250 lbs
- RV Ladders
- Exterior Ladders
- Aluminum
- 8 Feet Tall
- Silver
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Entry Door Lock for a Thor Motorhome
- Q&A: How to Choose the Correct Exterior RV Ladder for a Jayco Trailer
- Q&A: What is Length of Stromberg Carlson Stand Off SCS44SR
- Q&A: Rear Ladder Replacement for Tiffin Allegro Red Motorhome
- Q&A: Which Lippert On The Go Ladder for Tiffin Open Road 34PA
- Q&A: Recommended Exterior Ladder for a 2015 Jayco Redhawk Motorhome
- Q&A: Recommended Replacement to Replace Kimberly Ladder End Caps
- Article: How to Measure for Trailer Hitch Drop
- Article: 4 Common Myths About RV Solar Power
- Article: Can You Flat Tow a 2024 Jeep Compass?
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: How (and Where) to Connect an RV Propane Grill
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today