Trailer Suspension Makes Noise When Making Sharp Turn While Backing up
Updated 10/20/2015 | Published 10/19/2015 >
Question:
Hello, have my tandem car hauler trailer, with these axle purchased and 3500 1-3/4 leaf springs with suspension parts: PR4B APT5 trailer only used 3 times, total miles 150 yesterday when parking the trailer, I had to make an extremely sharp turn to back up and park it in my garage, during this time I heard a pop/knock noise coming from the suspension. Some forums ive read suggest this is normal at sharp turns, because I am putting a lot of torsion on these axles. No noise going straight, or at normal turns. Should I be concerned? After looking under trailer, everything seemed okay. thank you
asked by: Ryan
Expert Reply:
If everything checks out on the suspension and shows no sign of damage you should be good to go. You may have heard the shackles on the suspension moving and that caused the noise when you made the sharp turn to park the trailer. If everything checks out when you are towing normally, you should be fine.
Product Page this Question was Asked From
Dexter Trailer Axle Beam with EZ-Lube Spindles - 89" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 3500 lbs
- Spindles Only
- 74 Inch Spring Center
- 89 Inch Hub Face
- No Drop or Lift
- Dexter
more information >
Continue Researching
- Shop: Equal-i-zer High-Performance Lubricant - 4 oz
- Shop: RV Exterior Lighting
- Shop: Brophy Camper Scissor Steps - 4 Steps - Aluminum - Non-Slip Tread - 24" Wide - 300 lbs
- Shop: MORryde Safe-T-Rail Telescoping RV Hand Rail
- Search Results: handrail
- Search Results: torklift glow steps
- Shop: Replacement Gearbox for etrailer and Ram 5th Wheel Landing Gear
- Shop: LED Porch and Utility Light for RVs - Oval - Clear Lens
- Video: LED Identification Light Bar for Trailers over 80" Wide: The Breakdown
- Search Results: tandem trailer stabilizers
- Search Results: x brace
- Search Results: morryde trailer suspension parts
- Shop: MORryde Rubber Equalizers for Triple Axle Trailers - 35" Wheelbase - 8K
- Shop: MORryde X-Factor Crossmember for Standard Frame Hangers
- Q&A: Can You Drill Into An Aluminum Trailer To Install The CargoSmart D-Rings
- Article: How to Measure a Trailer Axle
- Article: How to Raise Your Travel Trailer Height
- Q&A: How to Determine Correct Hub Replacement for 1994 Jayco Eagle SD with Dexter Axle
- Q&A: Do I Need Additional Fuses for the Main Fuse Box on a 2024 Honda Pilot to Power a Wiring Harness?
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Is there a Brake Mounting Flange for a Square 3500 Pound Trailer Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: How to Measure Trailer Leaf Spring to Find Correct Replacement
- Q&A: How to Find Which Trailer Brake Assembly Goes on the Left or Right Side of a Trailer
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: How to Splice in Replacement 4-Way Trailer End Connector

