7K 8 Lug Disc Brake Kit Recommendation for Trailer
Published 10/14/2015
Products Featured in This Question
Question:
I have a 2008 Cargo Mate 38 ft goose-neck with 8 lug drum brakes, 7000 axles... Brakes last aprx one year... Very interested in updating to disc brakes... Do you have a Kitinch for two 7K axels, disc conversion, pump, lines, seals, bearings? Thanks
asked by: Dr.Phil
Expert Reply:
The Kodiak Disc Brake Kit # K2HRCM1337-9DAC is a 7k axle disc brake kit with a bolt pattern of 8 on 6-1/2 inch bolt pattern.
If you inner bearing is 25580 and your outer bearing is 14125A currently this setup would install on your trailers spindles. You would need two of these kits for both of your axles. This comes with bearings and grease seals.
For an actuator kit that includes brake lines, a breakaway system and an actuator you would want the part # CAR-HBA16-2.
I attached a help article on adding disc brakes to a trailer for you to check out as well.
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 13" Hub/Rotor - 8 on 6-1/2 - Dacromet - 7,000 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 7000 lbs
- Brake Assembly
- 8 on 6-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Wheel Center Cap For 4.9" Wheel Pilot Hole Diameter
- Article: Rust Prevention
- Q&A: Tonneau Cover That Will Fit 2020 Chevrolet Silverado With A Toolbox And 8 Foot Bed
- Q&A: Recommended Toolbox with Aluminum Rolling Tonneau Cover for 2020 GMC Sierra 3500
- Q&A: Distance Between Bolt Pattern of MORryde X-Factor Crossmember
- Q&A: Dimensions of MORryde X-Factor Crossmember End Plates
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Parts to Convert 2017 Grand Design Momentum 376TH to Electric Over Hydraulic Disc Brake
- Q&A: 7k Slip On Disc Brake Kit that Fits Dexter Axles of