Do Any Factory OEM Components Need to be Replaced to Install Engine Oil Cooler # D15602
Updated 06/18/2010 | Published 06/17/2010
Question:
when installing the DERALE STACKED PLATE ENGIN OIL COOLER KIT W/SANDWICH ADAPTER . DO I HAVE TO REPLACE THE EGR COOLER.
asked by: Lloyd
Expert Reply:
I spoke with my contact at Derale. He stated that you will not have to replace any components to install the Engine Oil Cooler Kit, # D15602.
When installing an engine oil cooler, you will need to make sure there is enough room for the sandwich adapter and oil filter. With the adapter in place, the oil filter will stick out about 2 inches further. Make sure you have enough room to remove and reinstall the filter with the adapter in place.
Product Page this Question was Asked From
Derale Stacked-Plate Engine Oil Cooler Kit w/ Sandwich Adapter (Multiple Threads) - Class III
- Engine Oil Coolers
- Stacked-Plate Cooler
- W/ Sandwich Adapter
- Class III
- 13W x 4-9/16T x 2D Inch
- With - 8 AN Inlets
- Derale
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Prop Rod Assembly & Clips For Leer HF350M Tonneau on 2020 Toyota Tacoma
- Q&A: Parts Needed to Add a Towing Package to a 2016 Ford Flex
- Q&A: Trailer Hitch and Wiring for a 2017 Ford Flex
- Q&A: Engine Oil Cooler for a 2015 RAM 1500 with 5.7L Motor
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Where is Brake Controller Install Port on 2016 Honda Pilot
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: How to Measure 5 on 5" Bolt Pattern for Fitment of Provider ST205/75R15 Tire on White Wheel
- Q&A: 2011 FJ Cruiser Transmission Cooler Recommendation
- Article: My Trailer Hitch Doesn't Fit