Does the Curt Hitch 13112 Require Factory Hitch for Installation
Published 08/24/2015
Question:
You guys might of already answered this but I just wanna make sure, does this hitch replace the factory one? I dont want both hitches on my vehicle and much rather put the 2inch hitch on instead
asked by: Steven R
0
Expert Reply:
The hitch part # 13112 that you referenced will sit underneath your factory hitch. This hitch requires your factory hitch to be present in order for it to install.
I attached a review video for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 8000 lbs WD GTW
- 2 Inch Hitch
- 800 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What Color is the Black Fade Replacement Fabric for etrailer Powered RV Awning e96QV When Rolled Up?
- Q&A: Looking for Replacement Lid for Ventline V2094 RV Roof Vent
- Q&A: Can Ball Mount be Used Upside Down to Use in Rise Position
- Article: How Much Solar Power Do I Need For My RV?
- Q&A: What is the Difference Between Load Range B and C Trailer Tires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How To Install Trailer Brake Controller and 7-Way Trailer Connector on International 4300
- Q&A: Trailer Wiring Harness For A 2022 Volkswagen Taos
- Q&A: Can You Flat Tow A 2023 Subaru Crosstrek With A Manual Transmission
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller Installation: Starting from Scratch
- Article: 5 Things to Know About Weight Distribution Hitches