Can 2 Gauge Wire be Used with Pollak Single-Pole, Round Pin Trailer Wiring Connector
Updated 07/14/2015 | Published 07/11/2015
Question:
The primary wire connection for this connector is 000. Can a #2 gauge wire be successfully crimped in this connector? If not is there an adapter that can be used?
asked by: Doug E
1
Helpful Expert Reply:
A 2 gauge wire is only a little smaller than double aught (2/0) by about 0.11 inches diameter so it could be used in connector # PK11852. But I advise soldering in the wire and not crimping it for the best results.
Triple aught (3/0) would be too large to fit.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Pollak Single-Pole, Round Pin Trailer Wiring Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 1 Round
- Plug Only
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: ISR Rails for 2012 Ford F-150 Wiith PullRite 2700 ISR Series SuperGlide
- Q&A: Wiring for HydraStar Electric-Hydraulic Actuator for Disc Brakes # HBA16
- Q&A: Replacement Tail Lights for a Kaper 1T-L6R Taillight
- Q&A: Recommended Replacement For A DICO 45263 Idler Hub
- Q&A: How Does Wire Attach to Pollak Single-Pole, Round Pin Trailer Wiring Socket
- Q&A: Are All Ford Factory Puck System Dimensions the Same
- Q&A: What is the Outer Width of the Buyers Products Black Receiver Tube # 337RT25824B
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Trailer Wiring Diagrams