What Wire Gauge to Use to Install Optronics Thin-Line LED Racing Light Kit # LS-108
Updated 07/09/2015 | Published 07/07/2015
Products Featured in This Question
Question:
What gauge wire do I need to use with the inline fuse that hooks to battery
asked by: Nate J
0
Expert Reply:
10-gauge wire like # 10-1-1 is typically used for 12V power feeds for a trailer connector but in the case of super-efficient LED lights like the Optronics Thin-Line LED Racing Light Kit # LS-108 you are fine using lighter 12-gauge wire # 12-1-1. LEDs draw about 1/10th of the power required by standard incandescent lights so you'll be just fine with this 12-gauge wire for your installation.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Optronics ThinLine LED Racing Light Kit w/ Harness and Power Switch - 12 Diodes - Oblong - Qty 2
- LED Strip Lights
- Rigid Light
- Exterior Light
- Hardwired
- 0 - 10 Inch Long
- White
- Optronics
more information >
Continue Researching
- Q&A: Do Slipper Springs Use Bushings on Both Ends?
- Q&A: How to Wire the Red Identification Light Bar with White LED Utility Light OPT88FR?
- Q&A: Which Way Do Slipper Springs Face on a Trailer
- Q&A: Is It Normal For Open Eye Spring To Hit Frame Of Trailer When Loaded?
- Q&A: Replacement Slipper Spring For a Boat Trailer With 4-Leaf Spring 25.5" Long
- Q&A: Installation of Slipper Spring with Open Eye End
- Q&A: Is Bushing Required on Open Eye End of Slipper Spring
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)