What Are Inside Dimensions Of Curt Coupler Safety Pin, # K-8P,
Updated 05/12/2010 | Published 05/11/2010
Question:
What are the dimensions of this pin from inside to inside of spring clip? I know pin is 1/4 diameter
asked by: gEORGE h
0
Expert Reply:
I went out to our warehouse and measured the Curt Coupler Safety Pin, 1/4 inch, # K-8P. I am sending a link to a picture of the safety clip. If you look at the picture the inside measurements of the safety clip from side to side would be 2-3/16 inches. The inside measurement from the pin to the top of the clip is 1-3/4 inches.
expert reply by:
Jeff D
0
Product Page this Question was Asked From
- Hitch Pins and Clips
- Snapper Pin
- 2-3/16 Inch Long
- 1/4 Inch Diameter
- 2-3/16 Inch Span
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Will Brophy Stake Pocket Tie Down Anchor TL2B Work With 6" Deep Stake Pocket?
- Q&A: Replacing/Upgrading The Suspension On A 2007 Colorado Tandem Axle 5th Wheel With LRE Suspension
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: How Does Buyers Products Pin with Lanyard # 3373006875 Fasten to Trailer?
- Q&A: Recommended Coupler Lock For Horse Trailer With 2-5/16 Inch Coupler
- Q&A: Correct Way to Wire Trailer Breakaway Kit
- Q&A: Disc Brake Assemblies For Changing A 12,000LB Dexter Axle To Hydraulic Disc Brakes
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Article: Gooseneck to 5th Wheel Adapters
- Article: Anti-Rattle Devices
- Article: Determining Trailer Tongue Weight
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)