What Is Turning Radius Of Wheel Masters Tire Pressure Valve Extender
Updated 06/25/2015 | Published 06/23/2015
Question:
180 degree bend aluminum double wheel valve extender What is the turning radius on these. Not sure the radio us will fit in hole of wheel thanks
asked by: Roger C
Expert Reply:
The width of the Wheel Masters Tire Pressure Valve Extender, part # WM8029180 is 1-5/16 inches.
I have attached a photo of the # WM8029180 you can check out. Since the width of the extender is 1-5/16 inches. The turning radius you would need for this would be 2-5/8 inches. To be on the safe side, I recommend a hole diameter of 2-3/4 inches to make sure you have plenty of room.
Product Page this Question was Asked From
Wheel Masters Tire Pressure Valve Extenders - 180-Degree Bend - Aluminum Rear Wheels - Qty 2
- Accessories and Parts
- Tire Repair Tools
- Valve Extenders
- Angled Extender
- Silver
- Wheel Masters
more information >
Continue Researching
- Q&A: Recommended Lock for a B&W Companion OEM 5th Wheel Hitch
- Q&A: Correct Floor Flange Seal for Dometic 300 Series Toilet
- Q&A: Recommended Valve Extender and Suspension Enhancement For 2018 Ram 3500 Dually 4x4
- Q&A: Is The Camco Extension Chord UL Listed Or ETL Listed?
- Q&A: Recommended Valve Extenders for a 2016 Ford F-450 Cab & Chassis
- Q&A: Valve Stem Extenders for 2020 GMC Sierra 3500HD Dually
- Q&A: Will the Brandmotion Radar Blind Spot Monitoring System Work if I Have a Metal Bumper
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Determining Trailer Tongue Weight