How Do Peterson Trailer Light # 432200 Mount to Trailer
Updated 06/10/2015 | Published 06/09/2015
Products Featured in This Question
Question:
I need mounting brackets for left and right boat trailer lights Peterson PM 452L. What do you recommend? Thank you,
asked by: Fred R
0
Expert Reply:
The Peterson lights you have like part # 432200 are stud mounted lights. For a bracket you could use the part # CE26057G.
To see how lights like this typically install on a trailer check out the video I attached. Basically the trailer will need to have a bracket on it already and you would have to drill 2 holes to mount this light.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Peterson Combination Trailer Tail Light - 6 Function - Incandescent - Square - Passenger Side
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Marker
- Square
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 4-3/4L x 4-1/2W Inch
- Red
- Peterson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Brake Assembly Needed For A Trailer With Timken 2788 And 1779 Bearings
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Q&A: Replacement Slide Out Motor For A 2007 Gulfstream Endura
- Q&A: How Difficult To Install EcoHitch EH75KR On A 2024 Cadillac Lyriq
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: How To Measure For Hub-Face And Spring Center Measurements On An Axle
- Q&A: Dimensions Of Holes On Lippert 1621 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed To Wire A 20' Open Deck Dual Axle Trailer With Brakes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Article: Trailer Hitch Balls