Does E-Coat on Disc Trailer Brake Rotors have to Be Removed where Pads Touch Rotor
Updated 05/28/2015 | Published 05/25/2015
Question:
Does the coating need sanded off where the pads contact the rotors or does it burn off with use?
asked by: Art
0
Expert Reply:
On a brake rotor with E-coat or any finish you do not have to do anything to remove the coating. Trying to remove it could result in damage to the rotor and affect braking performance. So all you would have to do is install the brakes, bleed the system, and you're done!
expert reply by:
Michael H
0
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 13" Hub/Rotor - 8 on 6-1/2 - Raw Finish - 7,000 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 7000 lbs
- Brake Assembly
- 8 on 6-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: What is the Difference Between the K2R89DDE and the K2R712DAC?
- Q&A: Parts Needed To Convert Trailer From Electric Drum Brakes To Electric Over Hydraulic Disc Brakes
- Q&A: Recommended Pattern for Rotating Trailer Tires on Triple Axle Trailer
- Article: Adding Electric Over Hydraulic Disc Brakes
- Q&A: How does a Vacuum Breaker Actually Work To Prevent Contaminated Fresh Water?
- Q&A: Can A 5 Bolt Trailer Coupler Be Installed Using 3 Bolts
- Q&A: Mounting Hole Dimensions for Buyers Products Straight Tongue Coupler # 3370091562
- Q&A: Mounting Hole Spacing on Buyers Products Straight Tongue Trailer Coupler 3370091562
- Article: Double-Eye Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
- Article: How to Measure a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs