How Is Stabil-Step Stabilizer Jack for Step Assembly Height Adjusted
Updated 05/26/2015 | Published 05/22/2015
Question:
do the twist up gradually or adjust with a hole and pin
asked by: Joe M
1
Helpful Expert Reply:
The Stabil-Step Stabilizer Jack for Step Assembly, part # JSS-7 adjusts by turning the plate to achieve the right height you need. I have attached a photo of the stabilizer that shows the threaded inner leg you can take a look at.
This stabilizer adjusts from 8 inches when retracted to 13-1/2 inches when fully extended. The square plates measure 4 by 4 inches, and this has a weight capacity of 750 lbs.
expert reply by:
Jeffrey L
1
click to enlarge
Product Page this Question was Asked From
Stabil-Step Stabilizer Jack for Step Assembly - 750 lbs - 8" - 13-1/2"
- Accessories and Parts
- RV Steps
- Jacks
- 750 lbs
- Black
- Stromberg Carlson
more information >
Continue Researching
- Q&A: What Size Screws Are Used For The Solera Head Covers?
- Q&A: Correct Replacement Motor for Lippert Coach Steps 128980
- Q&A: Replacement Joint Assembly Bolt For Lippert Electric Coach Step
- Q&A: How To Install Lippert Outriggers To Your RV To Install New Pull Out Steps
- Q&A: Will Lippert Pull Out steps part # LC432687 Fit 2017 Forest River Sandstorm 282SLR
- Q&A: Can 28 inch Wide 4-Step RV Steps Replace 27-1/2 inch Steps on RV
- Q&A: Recommended Steps for a 2012 Rockwood Mini Lite