Overall Dimension Of Brophy Trailer D-Ring Tie Down
Updated 05/20/2015 | Published 05/18/2015
Question:
What is the width of the D-ring?
asked by: Garry
0
Expert Reply:
I have attached a photo of the Brophy Trailer D-Ring Tie Down, part # SR15-C with the dimensions all noted.
The overall dimension of the D-ring is 2-1/4 inches and the inside width of the D-ring is 1-1/2 inches.
expert reply by:
Jeffrey L
0
click to enlarge
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 3-1/2" Wide - Surface Mount - 1,600 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 1600 lbs
- Bolt-On
- Folding
- Surface Mount
- Brophy
more information >
Continue Researching
- Q&A: Difference Between Pro Series Drop Leg Square Jacks PS1400950376 And PS1400960376
- Q&A: Where do I Install D-Ring Tie Downs on a 6x10 Wood Bed Utility Trailer
- Q&A: Recommended Replacement Jack For Shelby Bolt On Boat Trailer Jack
- Article: Cargo Tie-Down Methods
- Q&A: Recommendation for Re-Using Deck Board Screw Holes When Replacing Wood on Trailer
- Q&A: How to Wire the Dexter Electric Over Hydraulic Trailer Brake Actuator
- Q&A: How To Power Third Brake Light On Camper Shell Using 7-Way Trailer Connector
- Q&A: Can I Use an Adapter to Plug the 30 Amp ActiveStart Plug-In Soft Start to a 50 Amp Plug?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements