How Does the Tether of the Camco Vented RV Bumper Cap w/ Tether # CAM40324 Attach
Published 05/15/2015
Question:
how does the saver hook to bumper? do u have to drill a hole in bumper for a screw?
asked by: Bill
1
Helpful Expert Reply:
The "saver" portion of the Camco Vented RV Bumper Cap w/ Tether # CAM40324 that you referenced clips to the edge of the bumper that the cap is installed on. Basically you would push the clip over the edge of the bumper securing it, and then you would install the cap over it to secure it.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Camco Vented RV Bumper Cap w/ Tether - Qty 1
- Accessories and Parts
- RV Sewer Hoses
- Caps
- Bumper Caps
- Camco
more information >
Continue Researching
- Q&A: Will ShakeStopper Heavy Duty 2" Hitch MNT72VR Work For Carrying E-Bikes On A Travel Trailer?
- Q&A: Scissor Stabilizer Jack Base Hole Spacing Dimensions
- Q&A: Will B&W Continuum Work With 2024 Ford F-250 Towing 2021 Keystone Hideout 28RKSWE
- Q&A: Is Weight Distribution Needed for 2019 Chevy Silverado 1500 Towing 2019 Keystone Hideout 22RBWE
- Q&A: Recommended Stabilizer Jacks for a Rpod Trailer
- Q&A: Best Spare Tire Cover For An ST225/75R15 Trailer Tire
- Q&A: Availability of RV Grab Handle with Close to 8 inches Between Mounting Holes
- Article: How to Determine Tire/Wheel Diameter
- Article: How Much Solar Power Do I Need For My RV?
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Anti-Rattle Devices
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: How to Measure for Trailer Hitch Drop